Hide thumbs Also See for B-4000 XT:

Advertisement

Installation guide
B-4000
Tap options XL, XT, XR

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the B-4000 XT and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Billi B-4000 XT

  • Page 1 Installation guide B-4000 Tap options XL, XT, XR...
  • Page 2 Supply temp: min. 5°C, max. 30°C. 20mm 20mm 460mm 180mm * Where supply pressure is greater than 500 kPa a PLV must be fitted. Billi recommends PLV’s with anti-hammer properties. Do not install with water that is microbiologically unsafe or with water of 340mm 340mm unknown quality without adequate disinfection before or after the system.
  • Page 3 Installing the dispenser. XL, XT, XR. IMPORTANT: This Billi appliance is to be installed by a licensed trades person in accordance with AS/NZS 3500.1 and AS/NZ 3500.2 and in compliance with applicable state regulatory requirements. For correct operation of this appliance, it is essential to observe the manufacturer’s instructions.
  • Page 4 Additional installation – XR. Flush mount remote panel. Determine Remote Panel Location Plaster and Paint 70mm Dimensions and layout are shown in Start plastering as required. BRACKET diagram 9. Panel can be installed on a Wait for the plaster to dry before cleaning PANEL wall, benchtop or even inside a cupboard the bracket.
  • Page 5 Installing underbench module. 1. Flush Water Supply B-4000 Flush water supply pipework before installing the underbench unit by connecting 600mm flexible braided hose to the supply tap and running water into a bucket. Blockages/unit malfunction caused by debris are not covered under warranty.
  • Page 6 If any difficulties arise contact by a qualified person. Billi Australia Pty Ltd: Phone 1800 812 321 — WARNING: Do not connect any restrictor (Free call). Validate your warranty online at or pressure relief device to the vent pipe www.billi.com.au...
  • Page 8 Billi Australia Pty Ltd Designed and manufactured in Australia. 42 Lucknow Crescent, Thomastown As Billi Australia Pty Ltd has a policy of Victoria 3074 Australia continual improvement, all details are Telephone 1800 812 321 subject to change without notice. All...

This manual is also suitable for:

B-4000 xlB-4000 seriesB-4000 xr

Table of Contents