Kobalt KIW 5024B-03 Instruction Manual page 54

SAFETY INFORMATION
• Make sure that the cord is located so that it will not be stepped
on, tripped over, come in contact with sharp edges or moving
parts, or otherwise be subjected to damage or stress. This will
reduce the risk of accidental falls, which could cause injury and
damage to the cord, which could then result in electric shock.
• Keep the cord and charger away from heat to prevent damage
to the housing or internal parts.
• Do not allow gasoline, oils, petroleum-based products, etc.,
to come in contact with plastic parts. These materials contain
chemicals that can damage, weaken, or destroy plastic.
• An extension cord should not be used unless absolutely
necessary. Use of an improper extension cord could result in a
risk of fire and electric shock. If an extension cord must be used,
make sure that:
• The pins on the plug of extension cord are the same number,
size and shape as those of the plug on charger.
• The cord is properly wired and in good electrical condition.
• The size is large enough for A/C ampere rating of charger as
specified below:
Cord Length (Feet)
Cord Size (AWG)
NOTE: AWG = American Wire Gauge
• Do not operate the charger with a damaged cord or plug, which
could cause shorting and electric shock. If damaged, have the
charger repaired or replaced by a qualified service technician.
• Do not operate the charger if it has received a sharp blow, been
dropped, or has otherwise been damaged in any way. Take it to
a qualified service technician for an electrical check to determine
if the charger is in good working order.
25 ft. 50 ft.
16 16
kobalttools.com
6
100 ft.
16