Table of Contents
Advertisement
Equipment Required
a. USB storage device
b. Remote Control Unit
Firmware Update Procedure
[Preparation]
1. Prepare USB storage device.
2. Copy F/W-file to USB storage device.
Note: Make sure to use the blank USB Storage.
3. Make sure that the F/W-file's name is
"BIN_MSD_309.bin".
[Update procedure]
1. Turn the power on.
2. Insert USB storage device with F/W to TV set.
3. Press the [MENU] button on the remote control
unit to display Menu.
4. Select "SETUP".
5. Select "Software Update (USB)" and press [OK]
button.
The message "Are you sure?" will appear in the
screen.
6. Press [LEFT] button to select "YES".
7. Updating starts.
Note: Do not turn off the TV set and do not
remove the USB storage device while this
procedure.
8. The TV set will go off and turn back on
automatically when update completes.
[Confirmation of update]
1. Enter the service mode. (Refer to page 5-1.)
2. Press [4] button on the remote control unit to
display the "SW INFORMATION".
3. Check the "Build Time" section.
FIRMWARE RENEWAL MODE
7-1
LC10P_FW
Advertisement
Table of Contents
