Powering On The System; System Setup - First Steps; Introduction; Setup Instruction - Bosch DLA-AIOL0 Quick Installation Manual

1400 Series/4-bay IP Video Storage System
the chassis, then the two rear brackets positioned with just enough space to accommodate
the width of the telco rack. Finish by sliding the chassis into the rack and tightening the
brackets to the rack.
2.5

Powering On the System

The last thing to be done is to provide input power to the system.
1.
2.
3 System Setup – First Steps
3.1

Introduction

The following installation directive applies to the Bosch DLA disk array series and provides
information on Installation, Configuration and Service and Repair.
The Bosch DLA disk arrays are based on Microsoft Storage Server 2008. Microsoft Windows
Storage Server 2008 operating systems provide a user interface for initial server
configuration, unified storage appliance management, simplified setup and management of
storage and shared folders, and support for Microsoft iSCSI Software Target.
It is specially tuned to provide optimal performance for network-attached storage. Windows
Storage Server 2008 provides significant enhancements in share and storage management
scenarios, as well as integration of storage appliance management components and
functionality.
3.2

Setup Instruction

All Bosch DLA Series disk arrays are preconfigured with a default IP address and with default
iSCSI settings.
–
–
–
–
Detailed information, such as data sheets and user manuals, are available on the Bosch web
site www.boschsecurity.com under Product Catalog > CCTV > IP Video > Disk Arrays.
Default iSCSI settings are optimized for use with VRM. Only an experienced storage
administrator should make changes to these settings. Changing the default configuration is
only required either if VRM is not used or if the default settings are not appropriate for
another Bosch iSCSI application.
3.3

Setting the IP Address

The default IP address may be changed by either of two ways.
3.3.1

Remote Desktop Connection

1.
Bosch Sicherheitssysteme GmbH
Plug the power cord from the power supply unit into a high-quality power strip that
offers protection from electrical noise and power surges. We recommended using an
uninterruptible power supply (UPS).
Press the power button on the control panel to start up the system.
IP Address: 10.10.10.10 (1st port) and 10.10.10.11 (2nd port)
Net mask: 255.255.255.0
User: Administrator
Password: WSS4Bosch
Connect the system to your network through port 1 or port 2 and start up the system.
The system comes with the Remote Desktop Connection enabled. Log on to an
appropriate Client system either with Windows XP, Windows Vista or Windows 7
installed (Client hardware and software is not part of the shipment) with an IP Address in
the same network, e.g. 10.10.10.12 (net mask: 255.255.255.0).
Quick Installation Guide
System Setup – First Steps | en
- | V1 | 2011.03
25