Board Controller; Admin Console; Connecting; Built-In Help - Silicon Laboratories SLWSTK6060B User Manual

6. Board Controller

The Wireless STK Mainboard contains a dedicated microcontroller for some of the advanced kit features provided. This microcontroller
is referred to as the "Board Controller", and is not programmable by the user. The board controller acts as an interface between the
host PC and the target device on the radio board, as well as handling some house-keeping functions on the board.
Some of the kit features actively managed by the board controller are:
• The On-board Debugger, which can flash and debug both on-board and external targets.
• The Advanced Energy Monitor, which provides real-time energy profiling of the user application.
• The Packet Trace Interface, which is used in conjunction with PC software to provide detailed insight into an active radio network.
• The Virtual COM Port and
target processor.
• The Admin Console, which provides configuration of the various board features.
Silicon Labs publishes updates to the board controller firmware in form of firmware upgrade packages. These updates may enable new
features or fix issues. See 9.1 Firmware Upgrades

6.1 Admin Console

The admin console is a command line interface to the board controller on the kit. It provides functionality for configuring the kit behavior
and retreiving configuration and operational parameters.

6.1.1 Connecting

The Wireless Starter Kit must be connected to Ethernet using the Ethernet connector in the top left corner of the mainboard for the
admin console to be available. See
Connect to the Admin Console by opening a telnet connection to the kit's IP address, port number 4902.
When successfully connected, a

6.1.2 Built-in Help

The admin console has a built in help system which is accessed by the
level commands:
WSTK> help
*************** Root commands ****************
aem AEM commands
boardid Commands for board ID probe.
dbg Debug interface status and control
dch Datachannel control and info commands
discovery Discovery service commands.
net Network commands.
pti Packet trace interface status and control
quit Exit from shell
sys System commands
target Target commands.
time Time Service commands
user User management functions
The command can be used in conjunction with any top level command to get a list of sub-commands with description. For exam-
help
ple, will print a list of all available sub-commands of
pti help
WSTK> pti help
*************** pti commands ****************
config Configure packet trace
disable Disable packet trace
dump Dump PTI packets to the console as they come
enable Enable packet trace
info Packet trace state information
This means that running
pti enable
silabs.com | Building a more connected world.
UG317: EFR32FG14 2400/915 MHz 19 dBm Dual Band Radio Board and Wireless Starter Kit User's Guide
Virtual UART interfaces, which provide ways to transfer application data between the host PC and the
for details on firmware upgrade.
Ethernet Interface for details on the Ethernet connectivity.
prompt is displayed.
WSTK>
[ calibrate, current, dump, ... ]
[ list, probe ]
[ dnslookup, geoprobe, ip ]
[ nickname, reset, scratch, ... ]
[ button, flashwrite, go, ... ]
[ client, server ]
[ login,]
will enable packet trace.
command. The
help
[ info, mode,]
[ info ]
[ config, disable, dump, ... ]
:
pti
Board Controller
command will print a list of all top
help
Rev. 1.00 | 23