Table of Contents
Advertisement
i
o
t
nstAllAtion
F
He
Surround
Panel
Figure 60: Corner brackets for trim.
#8 screw
Side
Trim
Surround Panel
Figure 62: Screw to hold
the trim against the sur-
round.
Installation of Surround Panel onto Unit:
There are two (2) hooks on either side of the inside of the
panel. Line up the openings on the hooks with the screws
on the outside of either shroud (see Figure 63). Push the
surround in and push it down into place.
Installation
s
p
- i
urround
Anel
nsert
Installation of Trim:
The trim set for your surround panel must be installed before
installing the surround panel onto the unit, if not already done.
1. Attach one side trim to the top
trim, using a corner bracket
(see Figure 60) to secure pieces
together. There are two (2) main
pieces to each corner bracket (see
Figure 61). When installing the
corner pieces into the trim, the "B
FACE" sides must face each other
and the screw heads are to face
out. With the bracket in place and
the top and a side trim snug together, use
a flat head screwdriver to turn the two (2)
screws in the bracket to tighten it into the
trim.
3. Slide the two (2) attached trim pieces onto the surround panel.
4. Attach the other side trim piece to the top trim, using the same method used
in Step 1.
5. Place the second side of the trim on the surround panel in the same manner
used on the first side and secure in the same manner.
6. On the side trims, there are holes 2" (50 mm) from either end. Use a Phillips
screwdriver to place a #8 screw 1¼" long in each hole and tighten (refer
to Figure 62). This will keep the
trim tight against the surround.
:
Figure 63: Installation of Panel.
Figure 61: Two pieces of corner
bracket.
47
Advertisement
Table of Contents
