Table of Contents
Advertisement
F
p
H
ireplACe
oker
A fireplace poker can be hung at the back of the
unit, on either side, when not in use.
r
o
t
s
emovAl
F
He
Hrouds
A
B
B
Figure 59: Removal of right
Shroud.
46
Installation
- F
Angers
reestAnding
- i
:
nsert
1. If the surround panel is installed, remove it by lifting the panel straight
up then out.
2. For the right shroud, twist the handle on the air control clockwise to
remove it from the rod.
3. Pull unit forward a few inches, if possible.
4. Remove the screw, using a
through the firebox top into a bent over tab at the top of the shroud
(see A in Figure 58).
5. To remove the shrouds, loosen the two (2) torx T-20 screws that hold
the shroud to the unit (See B in Figure 58). Pull the shroud forward
past the T-20 screws (approximately ¾" [2cm]), then out to the
side.
6. To install the shroud, follow steps 1 through 5 in reverse order. Ensure
the shrouds are hooked behind both screws on either side.
:
Figure 58: Fireplace poker hanging.
5
/
16
" socket or wrench, that goes down
Advertisement
Table of Contents
