Table of Contents
Advertisement
l
A
A
p
i
egs
nd
sH
An
nstAllAtion
• Place the unit on the pallet on its
back.
• Attach the Leg Adaptor Plate to
the bottom of the unit using the
supplied screws
• 1700 Only: Attach the air channel
box to the front of the pedestal
spacer using two (2) T-20 screws
• Remove the rear two provided
Leg Box bolts, slide the Leg Box
assembly over the front bolts
located on the base of the unit, and
reinstall the rear bolts thru the Leg
Box holes and tighten all four (4)
bolts.
• Carefully remove the cast iron legs
from the packaging and secure each
leg with two (2) bolts provided.
• Secure all four (4) legs, push the
leg towards the center of the stove
and align the legs with the outer edges of the firebox.
• Stand the unit on the legs and set the unit in the location ready for installation.
i
o
H
nstAllAtion
F
eAt
The heat-efficiency shield is installed to lower the
clearances to combustibles on the flat top freestanding
model.
1. The unit must be in position for the installation and
with the venting ready to be assembled.
2. Loosen the two (2) top screws on the back of the
unit using a
/
" socket.
5
16
3. Place the heat-efficiency shield on top of unit.
4. Slide chimney connector through the heat-
efficiency shield and over the flue.
5. Lift the heat-efficiency shield and screw the
chimney connector to the flue.
6. Slide the heat-efficiency shield down and hook the
slot at the back of the shield, around the loosened
screws at the back of the unit.
7. Tighten the two (2) screws at the back.
Installation
- F
reestAnding
-e
s
- F
FFiCienCY
Hield
:
Figure 17: Installing Legs and Ash Pan Assembly.
F
t
reestAnding
lAt
op
Figure 18: Installing Heat Shield.
Note: Pre-installed on 1200
:
Chimney Connector
Heat Shield
Flue
Loosen screws
23
Advertisement
Table of Contents
