Door Installation - Vistaflame VF1200 Owner's Manual

d i
oor nstAllAtion
Please inspect all components for damage. If damage has occurred, please contact the courier company,
dealer, or distributor and have components repaired or replaced before installation. Remove the door
from the packaging. Inspect the door assembly for damage.
1. Install door handle as shown in Figure 50.
Figure 51: Installation Door onto Unit.
4. Place a hinge cap on each of the
pins. WARNING: The hinge caps are
removable, therefore please keep out
of the reach of children under 3
5. Please clean all fingerprints off of
all plated surfaces, with denatured
alcohol on a soft cloth, before firing the
unit each time. Fingerprints, etc., can
become permanently etched into the
plating if not removed before operating
the stove.
NOTE: When the door is installed on the
unit and the handle closed, ensure that
the spring handle is at the 4:00 position.
42
Installation
:
DO NOT USE DOOR IF GLASS IS BROKEN.
2. Place the door assembly on the two (2) hinge pins
mounted on the body of the unit. Refer to Figure 51.
3. Open and close the door, applying pressure down, to
ensure the door assembly is properly seated on the
hinges. Refer to Figure 52.
Figure 52: Closing Door.
Spring Washer
Furel
Figure 50: Installation Door Handle
Hardware.
Handle
damper handle
onto slider damper
control on the side
Nut
Cast Latch
Washer (x2)
Close the door
assembly and
turn the door
handle
downwards
until door is
tight.
Thread slider
of the unit.