Table of Contents
Advertisement
5.
Place chute onto chute base and secure chute control head to chute support
bracket with clevis pin and cotter pin removed earlier. See Figure 4.
6.
Finish securing chute control head to chute support bracket with wing nut
and hex screw removed earlier. See Figure 5.
7.
Insert the chute directional control into the support bracket on the rear of
the dash panel. See Figure 6.
8.
Remove the hairpin clip from the rear of the chute control head.
9.
Insert chute directional control into rear of the chute control head. Secure
the chute directional control to the chute control head with the hairpin clip
removed earlier. See Figure 7.
Figure 4
Figure 5
ASSEMBLY
9
Figure 6
Figure 7
Advertisement
Chapters
Table of Contents
