Enclosure Installation; Preparation; Unpacking - Tripp Lite SmartRack NEMA 4 Owner's Manual

4. Enclosure Installation

Caution! Read All Instructions and Warnings Before Installation!
Warning: Rack enclosures can be extremely heavy. Do not attempt to unpack, move or install the enclosure
without assistance. Use extreme caution when handling the enclosure and be sure to follow all handling and
installation instructions. Do not attempt to install equipment without first stabilizing the enclosure.

4.1 Preparation

The enclosure must be installed in a structually sound area that is able to bear the weight of the enclosure, all the equipment
that will be installed in the enclosure and any other enclosures and/or equipment that will be installed nearby. Before
unpacking the enclosure, you should transport the shipping container closer to the final installation location to minimize the
distance you will need to move the unit after the protective packaging has been removed. If you plan to store the enclosure for
an extended period before installation, follow the instructions in the Storage and Service section.
You need several tools:
• Level
• Phillips-head screwdriver
• Appropriate tools for wall mounting

4.2 Unpacking

1 Move shipping pallet to a firm, level surface.
2 Open box and remove the four foam corner protectors. Save all packing materials for later use unless you are certain
they will not be required. Packing materials are recyclable.
With one person on each side, carefully lift the enclosure out of the box and place on a firm, level surface.
3
Examine the enclosure for any damage or loose parts. Confirm all parts are present. If anything is missing or damaged,
4
contact Tripp Lite for assistance. Do not attempt to use the enclosure if it has been damaged.
Never extend more than one component from the enclosure at a time.
Warning: Never attempt to lift or install without adequate help.
Use at least two people to unpack the enclosure.
Do not try lifting the enclosure alone.
You also need the following hardware:
• Appropriate hardware for wall mounting (not included)
4