Page 2
Parts List Front Upright Rear Upright Top Flange Base Flange Horizontal Beam PDU Bracket SRCASTER Kit (Optional, Sold Separately) M10 Acorn Nut M10 Flat Washer M6x12 Phillips M6x16mm Hex M6 Hex Nut M6 Flat Washer Caster Head Screw Head Screw Required tools (User Supplied): •...
Page 3
step Lay out parts on the floor or a stable work surface and assemble as shown. step Attach the washers and acorn nuts, but leave them loose. This will allow the unit to flex later in the assembly process.
Page 4
step Attach the washers and acorn nuts, but leave them loose. step...
Page 5
step Lay rear upright on the unit. Pull apart the base flange and horizontal beam . Align the holes at the end of the upright with the studs in the horizontal beam and push the upright onto the beam . Push the base flange and horizontal beam back together.
Page 6
step Using an open end wrench (user- supplied), tighten all acorn nuts firmly. Place the rack upright on a level surface and confirm it’s stable. step (Optional) Attach PDU Brackets...
Page 7
(Optional) Attach Casters Warning: Do not attempt to install casters while equipment is installed in the rack. Note: Installation requires Tripp Lite’s Heavy- Duty Rolling Caster Kit (model SRCASTER, sold separately) Configuration 1 Configuration 2...
Page 8
Product Registration Visit www.tripplite.com/warranty today to register your new Tripp Lite product. You’ll be automatically entered into a drawing for a chance to win a FREE Tripp Lite product!* * No purchase necessary. Void where prohibited. Some restrictions apply. See Web site for details.