After Use Cleaning - Hyundai BPM 700 Instruction Manual

3) The air pressure in the arm cuff will slowly start to deflate. Once a tendency towards high
pressure has been recognised the arm cuff will inflate a bit more and the pressure in the arm
cuff will increase. As soon as the pulse is recognizable, the
the monitor.
4) The measurement results of systolic pressure, diastolic pressure and pulse rate (pulse) will
be displayed on the monitor.
5) You can finish the measurement at any time by pressing the ON/OFF key.
6) If an "E" symbol appears on the monitor, the measurements were not properly taken. Please
follow the TROUBLESHOOTING instructions and repeat the measuring.
7) The readings will be automatically stored into the memory.Switch off the device by pressing
the ON/OFF key, alternativelly the device will switch off automatically after 1 minute.
Note
If the pressure in the arm cuff is not sufficiently high or if the arm cuff moved, the arm cuff will
start inflating again – automatic pumping-up to a suitable higher pressure value, this is not a de-
vice error.
TAKING AND STORING A READING
The device can of recorded data 30 total. Each data set consists of values of systolic and dia-
stolic pressure and pulse rate.
Press and hold the ON/OFF key for 3 seconds. The device enters the memory mode and values
for the last readings are displayed on the monitor. Press the ON/OFF key to be able to move up.
* The most current measured value will be stored in memory "1". If the memory is full, the oldest
value will be deleted.
If an irregular heart beat has been detected during the measurement this information will also be
stored and it will be displayed when recalling the measured values from the device memory.
* When replacing the batteries, the stored data will be kept in the memory.

After Use Cleaning

1) Do not use coarse and aggressive cleaning agents (e.g. petrol) to clean the device.
2) Clean the device with a soft and dry cloth.
3) Do not wash or dry-clean the arm cuff, wipe it with a moist cloth if necessary.
4) Do not stretch the arm cuff or air tube by force and do not bend them.
ENG - 46
symbol will be displayed on