After Use Cleaning - Hyundai BPM 850 Instruction Manual

8) Switch off the device by pressing the ON/OFF key, alternativelly the device will switch off
automatically after 1 minute.
Note
If the pressure in the arm cuff is not sufficiently high or if the arm cuff moved, the arm cuff will
start inflating again – automatic pumping-up to a suitable higher pressure value, this is not a de-
vice error.
TAKING AND STORING A READING
The device can store 90 of recorded data. Along with the blood pressure values, information on
the time, date and year of the measurement is also stored so that it would be possible to corre-
spondingly determine the average values.
Each data set consists of values of systolic and diastolic pressure and pulse rate.
Press and hold the MEM key for 3 seconds. The device enters the memory mode. Press the
MEM key to be able to move up in the memory or the SET key to be able to move down in the
memory.
* The most current measured value will be stored in memory "1". If the memory is full, the oldest
value will be deleted.
* When replacing the batteries, the stored data will be kept in the memory.
In case that you wish to remove all data stored in the memory, press and hold the "SET" key for
5 seconds. The display shows "No" (all readings for the given person have been deleted).
Important notice:
If you release the memory key prematurely, the values will not be deleted. When you delete
one specific value, the next previously taken value will take its place in the memory. By deleting
the measured value new respective averages will be calculated.

After Use Cleaning

1) Do not use coarse and aggressive cleaning agents (e.g. petrol) to clean the device.
2) Clean the device with a soft and dry cloth.
3) Do not wash or dry-clean the arm cuff, wipe it with a moist cloth if necessary.
4) Do not stretch the arm cuff or air tube by force and do not bend them.
STORAGE
ENG - 46