Putting Into Operation; Switching On; Selecting The Temperature Setting - Beurer UB 86 XXL Instructions For Use Manual

• Do not connect the defective heated underblanket with another controller of the same type. This
would trigger a permanent switch-off via the controller safety system.

4.2 Putting into operation

Spread out the heated underblanket flat onto your mattress starting at the foot end.
Then put on your bedsheet in the usual manner so that the heated underblanket is
between your mattress and the bedsheet
CAUTION
Make sure that the heated underblanket is spread out entirely flat and that it
will not rumple up or crease when in use.
• To operate the heated underblanket connect the control to the heated underblanket
by plugging in the connector.
• Then plug in the supply plug into the mains outlet.

4.3 Switching on

Slide the ON/OFF switch [6] sideways [1] to the ON ( I ) position to switch on the electric underblanket.
When switched on, the display [2] lights up and at first displays all the segments for approx. 2 seconds. After
that, the following basic settings are displayed:
Temperature setting for body area: 0
Temperature setting for foot area: 0
Automatic switch-off time: 1 h (= 1 hour)
NOTE:
The illuminance level drops after approx. 5 seconds so that your sleep is not disturbed during the night.
NOTE:
This electric underblanket has a rapid heating function, allowing for faster warming in the
first 15 minutes. During this time, "Turbo" flashes on the display.
If the underblanket is rapidly switched off and then on again during the first 15 minutes,
the fast heating function is deactivated for safety reasons. In this case the word "Turbo"
does not appear on the display. However the electric underblanket is heated as normal. To reactivate
the fast heating function the electric underblanket must be completely switched off for 20 minutes.

4.4 Selecting the temperature setting

Press the button [3] to select the temperature setting for the body area.
Press the button [5] to select the temperature setting for the foot area.
Level 0: off
Level 1: minimum heat
Level 2 – 8: individual heat
Level 9: maximum heat
NOTE:
Switching sequence of the temperature settings: 0 – 9 – 8 – 7 – 6 – 5 – 4 – 3 – 2 – 1 – 0 – 9 ...
WARNING
If the heated underblanket is used continuously (for several hours) it is
recommended to use the lowest setting of the control to avoid overhe-
ating of the user.
16