Table of Contents
Advertisement
Building in the appliance
On furniture with door fittings (e.g.
stubs, seals etc) the dimension of
these must be taken into account to
ensure there is a gap all round of
42 mm.
^ Pull the appliance forwards by the
dimension of the door fitting to keep
the gap at 42 mm all round.
Tip: Remove the door fittings. This will
ensure that the door is flush with the
surrounding kitchen unit furniture doors.
If the all round gap of 42 mm is not
maintained between the appliance
casing and the front edge of the
housing unit side walls the door may
not shut properly.
This can cause ice to build up,
condensate to accumulate and lead
to faults in the appliance. These can
all lead to increased energy
consumption.
^ Tighten screws k in fixing bracket
j.
60
^ Align the appliance on both sides
using the adjustable feet so that it is
level.
Advertisement
Table of Contents
