Table of Contents
Advertisement
Fault message at the end of a programme
Problem
Check dosage
Hygiene info: run a
programme at min.
75 °C or the "Clean
machine" pro-
gramme
Align the washing
machine
The messages will appear at the end of the programme and when the washing
machine is switched on and need to be confirmed with the OK sensor.
Cause and remedy
Excessive foam has built up during washing.
With TwinDos, check the dosage amount set.
Reduce the amount set in 10 % increments.
Use less detergent next time and follow the manu-
facturer's instructions on dosage given on the
packaging.
A wash programme using a temperature above 60 °C
has not been run for a long time.
Turn the programme selector to Further pro-
grammes/.
Touch the sensors until
in the display.
Touch the OK sensor to confirm.
The following appears in the display:
Touch the OK sensor to confirm.
Run the
Clean machine
chine cleaner or a universal powder detergent.
This will clean the washing machine and prevent a
build-up of bacteria and odours.
The
Pre-ironing
extra option which runs at the end of
the programme could not be carried out properly.
Check whether the washing machine is aligned
correctly as described in "Installation and connec-
tion – Levelling the machine".
Check whether the maximum delivery head of 1 m
has been exceeded.
If the fault message appears again, contact Miele.
The washing machine can still be used, however
without the
Pre-ironing
Problem solving guide
Maintenance
Clean machine
programme using Miele ma-
extra option.
appears
63
Advertisement
Table of Contents
