Table of Contents
Advertisement
Fault message at the end of a programme
Problem
Check dosage
Hygiene info: run a
programme at min.
75 °C or the "Clean
machine" pro-
gramme
Align the washing
machine
The messages will appear at the end of the programme and when the washing
machine is switched on and need to be confirmed with the OK sensor control.
Cause and remedy
Excessive foam has built up during washing.
With TwinDos, check the dosage amount set.
Reduce the amount set in 10 % increments.
Use less detergent next time and follow the manu-
facturer's instructions on dosage given on the
packaging.
When washing, a wash programme using a temperat-
ure above 60 °C has not been run for a long time.
Turn the programme selector to Further pro-
grammes/.
Touch the sensor controls until
appears in the display.
Touch the OK sensor control.
The following appears in the display:
Touch the OK sensor control.
Run the
Clean machine
chine cleaner or a universal powder detergent.
This will clean the washing machine and prevent a
build-up of bacteria and odours.
The Pre-ironing extra option which runs at the end of
the programme could not be carried out properly.
Check whether the washing machine is aligned
correctly (see "Installation – Levelling the ma-
chine").
Check whether the maximum drain height of 1 m
has been exceeded.
If the fault message appears again, contact the Miele
Customer Service Department. The washing machine
can still be used, but without the Pre-ironing extra
option.
Problem solving guide
Clean machine
programme using Miele ma-
Maintenance
65
Advertisement
Table of Contents
