Advertisement
LCD Screen operation - Section C
2. - Filter Reset
After replacing the filter, the
counters should be reset
3 - Lux Sensor Calibration
NOTE: Conduct calibration under normal light conditions
selecting 'Lux Sensor-> OFF'. When the room is darkened (below the
calibrated light level), the tap lights will turn OFF after aprox 30 seconds.
LCD Screen operation - Section D
D
Service
This section is reserved for service technicians only
Note: In Australia, call a licensed electrician, plumber or Zenith office on
1800-638-633, for assistance, service, spare parts or enquiries
802262NZ - Chilled HT User Guide - 11.16 - v2.01
Press the [MENU] button for main
1.
menu.
Press the [Install] button.
2.
Press the [Filter Reset] button.
3.
To set the filter life or edit filter
4.
usage, refer to section G- Filter.
1. Press [MENU] button for main menu.
2. Press [Install] button.
3. Press [Lux Sensor Calibration]
button.
4. The lights on the Tap head will flash
to confirm calibration.
5. Check for correct tap operation by
Page 11 of 20
Advertisement
