Appliance Equipment; Installation - BOMANN GS 7330 Instruction Manual

 To prevent hazards, check the appliance for any
transport damage.
 In case of damage, do not put the appliance into
operation. Contact your distributor.
NOTE:
Production residue or dust may have collected on the
appliance. We recommend cleaning the appliance
according to chapter "Cleaning and Maintenance".

Appliance Equipment

Appliance overview
Delivery scope
3x glass shelf, 1x open drawer, 2x door storage rack,
3x closed drawer, 1x ice-cube tray, 1x door handle
incl. fixing screws with covers,
opening:
1x door hinge cover, 1x door stopper

Installation

Conditions for the installation location
 Good ventilation is required around the appliance
to dissipate the heat properly and to guarantee ef-
ficient cooling operation at low power consump-
tion. Enough clearance is necessary.
1 Interior light
2 Glass shelves
3 Open drawer
4 Closed drawers
5 Door storage
racks
for reversing the door
Gap to the back approx. 50～70 mm, to the
-
side walls and above the device each approx.
min. 100 mm;
Place the appliance so that the appliance door
-
can open without being impeded.
 Only install at a location with an ambient tempera-
ture suitable for the climate class of the appliance.
The climate class can be found under "Technical
Data" and on the rating label located in the interior
or on the appliance rear.
 Place the appliance on a steady and safe surface.
If the appliance is not horizontally leveled, adjust
the feet accordingly.
 Avoid the installation:
near heaters, next to a stove, direct sunlight or
-
any other heat sources;
at locations with high humidity (e.g. outdoors,
-
bathroom), as metal parts would be suscepti-
ble to corrosion under such circumstances;
near volatile or flammable materials (e.g. gas,
-
fuel, alcohol, paint, etc.), in rooms which may
have poor air circulation (e.g. garages).
Do not expose the appliance any weather.
-
Assembling the door handle
 Carefully remove the cover caps on the door outs-
ide.
 Tighten the handle with the enclosed screws in
the holes.
 Put the included screw covers on.
19