Operation - Tripp Lite PINV2000SWL-120 Owner's Manual

Operation

Operating Modes
After mounting and connecting your Inverter according to the
instructions in this manual, use the ON/OFF switch on the unit or the
PINVSWRM remote control power on the inverter.
ON: When you set the switch to the ON position, the Inverter provides
AC power to connected equipment by converting DC power from your
vehicle's battery. The green LED will illuminate to indicate it is working.
OFF: Set the switch to the OFF position to shut down the Inverter
completely. Doing this will prevent it from drawing power from your
vehicle's battery. Also set the switch to the OFF position to reset the
Inverter if it has shut down due to low battery, overload or other critical
condition.
Remote Control (Optional): Ensure the inverter power switch is
in the OFF position prior to connecting the remote cable. Press the
I/O button to turn ON the inverter. The green power status LED will
illuminate to indicate it is working. You can then power the inverter
ON/OFF from a remote location with the included PINVSWRM remote.
This remote switch can be mounted in the vehicle or a permanent
mount application (see Mounting section for more information). The
green LED on the remote will illuminate to indicate the inverter is in
the ON operating mode. The Fault LED will illuminate an issue with its
operation. See Troubleshooting/Maintenance section to identify the
fault and ways to correct it.
1. Connect the Inverter (see Battery Connection section).
20
STATUS
ON/OFF
PINVRM