Operation - Tripp Lite PINV750 Owner's Manual

Operation

Operating Modes
After mounting and connecting your Inverter according to the
instructions in this manual, use the ON/OFF switch to choose the
Inverter's operating mode.
ON: When you set the switch to the ON (I) position, the Inverter
provides AC power to connected equipment by converting DC power
from your vehicle's battery. The green LED will illuminate to indicate it
is working.
OFF: Set the switch to the OFF (O) position to shut down the Inverter
completely. Doing this will prevent it from drawing power from your
vehicle's battery. Also set the switch to the OFF position to reset the
Inverter if it has shut down due to low battery, overload or other critical
condition.
1. Connect the Inverter (see Battery Connection section).
2. Switch the Inverter's ON/OFF switch to the ON (I) position.
3. The green LED indicator will illuminate, indicating the Inverter is
receiving power.
4. Switch the Inverter's ON/OFF switch to the OFF (O) position. The
green LED may flash briefly and/or the internal speaker may beep
briefly. This is normal.
5. Make sure the device to be operated is turned OFF.
6. Plug the device into the Inverter's AC outlet.
18-06-149-93385F.indb 16
16
7/16/2018 3:50:25 PM