Table of Contents
Advertisement
Figure 66. Drive shoe and blank panel removal
4. Remove the cover plate adjacent to the power supply as shown in Figure 67 on
Note: With a blank panel or tape drive removed, there is access to moving
parts. DO NOT reach into open cavities.
a. Loosen the captive retainer screws at the top center and lower left of the
drive module.
b. Pull straight back on the drive shoe handle to remove the drive. Some effort
will be required to overcome the initial resistance of unplugging the module
from the receiver.
c. Continue to slide the drive out while fully supporting the module until the
drive load handle has cleared the back of the library.
page 74.
a. Remove two screws from the back of the cover plate.
b. Remove two inner screws from inside the drive shoe slot.
c. Remove top screw. Rack-mounted modules must be slid forward to access
the top cover screw.
Get other manuals https://www.bkmanuals.com
Appendix B. Adding a library module
73
Advertisement
Table of Contents
