Feiyu MiNi 2D Firmware Upgrade Manual

Gimbal

Download this manual

MiNi 2D Gimbal Firmware Upgrade

Attention :

 The firmware upgrade software only supports the Windows operation

system provisionally.

 Please operation step by step strictly and make sure click the "OPEN"

button to open the com port before the USB Mini terminal of the USB cable

connect to the gimbal.

 If you want to get the current version of the gimbal, please execute step

3~6.

Please refer to the following connection diagram, connect the USB cable to the

USB connecter before upgrading.

Download the USB driver from FY-TECH official website and install it.

Then download the dedicated firmware upgrade software "UPDATE FOR

2AXIS GIMBAL" and the firmware for the MINI2D gimbal.

After successful install the USB driver,

connection diagram, connect the USB cable to the USB connector then insert

the USB connector to the computer. Confirm the port number in device

manager (If the port number is more than COM10, please modify to the

available number which within COM10 ).

Guilin Feiyu Electronic Technology Co., Ltd

Guilin Feiyu Electronic Technology Co., Ltd.

Manual

Connection Diagram

http://www.feiyu-tech.com

- 1 -

please refer to the above

service@feiyu-tech.com

Page 1 Guilin Feiyu Electronic Technology Co., Ltd. MiNi 2D Gimbal Firmware Upgrade Manual Attention :  The firmware upgrade software only supports the Windows operation system provisionally.  Please operation step by step strictly and make sure click the “OPEN” button to open the com port before the USB Mini terminal of the USB cable connect to the gimbal.
Page 2 Guilin Feiyu Electronic Technology Co., Ltd. Open the software ——“UPDATE FOR 2AXIS GIMBAL” 。 Software interface is shown in following picture.： Choose the correct port number and the correct baud rate-115200, then click OPEN button to open the com port.(The serial port number should be the same as the port number which checked in step 2, for example COM4).
Page 3 Guilin Feiyu Electronic Technology Co., Ltd. Click on OPEN FILE button and choose the correct firmware for the gimbal. Click on UPDATE button to start upgrading, process of upgrading will display on the software. Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyu-tech.com...
Page 4 Guilin Feiyu Electronic Technology Co., Ltd. Data of firmware being sent to the gimbal completely, please click Confirm button to finish the upgrade. Close the software then remove the USB cable. The gimbal can be used normally. –––– –––– Note: We reserve the right to change this manual at any time! And the newest edition will be shown on our website www.feiyu-tech.com.