Feiyu MiNi 2D Manual

!
WARNING ! WARNING !
1. GoPro camera must be installed
before supplying power to the
Gimbal. Failure to do so will result
in damage to the gimbal motors.
2. Make sure that the connection to
the computer is done by the
USB Connector
2
Install Step
Install the damping ball to the adapter (Up),
Ⅰ
then install the adapter (Up) to the aircraft.
V hanger is optional part to use if necessary.
1
1 2
Adapter
( Up )
3
Install Mode
Vertical Installation Diagram
MiNi 2D 2-Axis Brushless Gimbal For Aircraft
Suitable For Gopro4 / Gopro3+ / Gopro3 or the cameras with the similar size
1
Introduction
MiNi 2D 2-Axis Brushless Gimbal ( For aircraft ) suitable for GoPro4,GoPro3+ / 3 or cameras with similar size.
Can be easily mounted in fixed wing, multirotor, helicopter for aerial photography, and can work
independently only need power supply.
You can assemble the gimbal properly according to the drawing, and then install the video camera on it.
There is no need to set up and adjust the parameter. For the first use, power on the Gimbal, and then
keep it static for a while, after its reset, the gimbal will be in a level position automatically. Then you can use
it normally.
Install the damping ball to the Adapter(Down)
Ⅱ
3
5
3
Adapter
( Down )
Damping Ball
Gimbal Connection Diagram
Inverted Installation Diagram
Default
1
3
2
4 5
M2×25mm
Knurled Thumb Screw
Adapter
(Down)
Install the camera
Ⅲ
4
END
V Hanger
Screw
Hexagonal Socket Head Cap Screw
(Not Included）
Roll Control
Pitch Control
Mode Switch
( Only use in 3-axis gimbal )
Video Output
Power Connection
Manual Version 3.0
M2.5×5mm
V Hanger
Note: RC receiver needs to be
powered separately
5V
Video Output And
Camera Charging
Video
Control
Cable
Video
GND
This interface can be output 5
voltage and input analog video
signal of GoPro camera
Install "V" Hanger