Qnet Vtol And Ni Elvis Ii Setup; Qnet Vtol Components - Quanser QNET 2.0 VTOL User Manual

4 QNET VTOL and NI ELVIS II
Setup
The procedure to install a QNET VTOL module on the NI ELVIS II
components used in the installation procedure are located and marked by an ID number in Figure 4.1, and described
in Table 4.1.
If the equipment is used in a manner not specified by the manufacturer, the protection
provided by the equipment may be impaired.
Caution

4.1 QNET VTOL Components

To setup the QNET VTOL system, you need the following components:
1. QNET VTOL PCB (shown in Figure 1.1)
2. VTOL module (shown in Figure 1.1)
3. QNET VTOL power supply (TRUMPower FRA072-S24-4, P/N: TRA72-S24-4G-509L, Output 24 VDC, 3 A)
Use only the power supply provided with with the QNET VTOL.
Caution
4. Power cable
5. Schurter 0034.3121, 5 mm × 20 mm, 2.5 A, 250 VAC, time-lag fuse
(+)
is detailed in this section. The NI ELVIS II
QNET VTOL - User Manual
(+)
12