Table of Contents
Advertisement
3 QNET VTOL Assembly
Instructions
Follow the instructions below to setup the QNET VTOL:
1. Remove the four thumbscrews that are used to attach the VTOL base to the QNET board for transport.
2. Rotate the support arm upright, and align the screw holes on the bottom of the support with the four holes
indicated on the bottom surface of the QNET board.
(a) Bring the support arm upright
3. Tighten the four thumb screws to secure the VTOL assembly to the QNET board.
4. When fully assembled, the system should resemble Figure 1.1.
QNET VTOL - User Manual
Figure 3.1: Initial VTOL Setup Procedure
(b) Align the screw holes
v 1.0
Advertisement
Table of Contents
