Advertisement
Quick Links
Quick Start Guide:
STEP 1
Check Components and Details
Make sure your QNET DC Motor experiment includes the following components:
1
STEP 2
Additional Components Required
To complete your QNET DC Motor setup, you will also need the following hardware:
1
STEP 3
Install LabVIEW and Add-Ons
Make sure the following versions of LabVIEW™ and required add-ons are installed:
1. LabVIEW™ 2012 or later
2. NI DAQmx 9.5.5 or later
3. NI ELVISmx 4.4 or later
4. LabVIEW™ Control Design and Simulation Module 2012 or later
QNET 2.0 DC Motor
2
3
1. Quanser QNET 2.0 DC Motor board
2. 24VDC, 3.0A Power Supply
Note:
The QNET curriculum resources are
available for download at www.ni.com/qnets
2
1. NI ELVIS II or NI ELVIS II
workstation
2. +5VDC / 5A, +15VDC / 2A,
-15VDC / 0.8A Power Supply
3. USB Cable
Note:
All references to NI ELVIS II
in this guide apply to both NI
ELVIS II and NI ELVIS II
+
devices.
+
Advertisement
Related Manuals for Quanser QNET 2.0 DC Motor
Summary of Contents for Quanser QNET 2.0 DC Motor
- Page 1 QNET 2.0 DC Motor STEP 1 Check Components and Details Make sure your QNET DC Motor experiment includes the following components: 1. Quanser QNET 2.0 DC Motor board 2. 24VDC, 3.0A Power Supply Note: The QNET curriculum resources are available for download at www.ni.com/qnets...
- Page 2 STEP 4 Set up the Hardware To set up the QNET DC Motor, please read the following instructions carefully. For full details, see the QNET DC Motor User Manual. Ensure that the NI ELVIS II power switch is in the off position. Place the handle on the front of the QNET Slide the PCI connector at the back of the board over the bracket located on the front...
- Page 3 Power on the NI ELVIS II using the power switch on the back of the unit. The READY and ACTIVE LEDs on the top NI ELVIS II panel should briefly light, and the READY LED stays on. Power on the QNET DC Ensure that the Motor by turning the +15V, -15V, +5V,...
- Page 4 For full range of QNETs visit www.ni.com/quanser. LEARN MORE For advanced control tools for teaching and research, visit www.quanser.com ©2014 Quanser Inc. All rights reserved. NI ELVIS is a trademark of National Instruments. QNETs were developed by Quanser exclusively for National Instruments.