Specifications - Draytek Vigor2500V Series Quick Start Manual

1.2 Specifications

For Vigor25100V/Vi
VPN
Up to 2 simultaneous VPN tunnels
Dial-in or dial-out, LAN-to-LAN or
Teleworker-to-LAN
Supported Protocol: PPTP, IPSec,
L2TP, L2TP over IPSec
Encryption: AES, MPPE, and
hardware- based DES/3DES
Authentication: MD5 and SHA-1
Key management: IKE
IKE authentication: pre-shared key.
LAN-to-LAN, Teleworker-to-LAN
ADSL
Compatible with ADSL lines up to
downstream 8 Mbps
Supports PPPoE/PPPoA, and
MPoA
VoIP
Supports one FXS port
G. 168 line echo-cancellation
Gain control
Jitter Buffer (250 ms)
Voice Codec:G.711 A/u law, G.729
A/B, VAD/CNG
Tone generation and detection:
DTMF, Dial, Busy, Ring Back
Protocol: SIP, RTP/RTCP
LAN
4-port 10/100M Base-TX Ethernet
switch
DHCP server for IP assignment (up
to 253 users)
DNS cache and proxy
Routing support:RIPv2, Static
Route (not applicable in UK)
Supports port-based Virtual LAN
(for Vigor2510V/Vi)
Power Consumption
15V DC 15Watt
For Vigor2500Vi/2510Vi
ISDN
Euro ISDN compatible
Automatic ISDN backup
64/128Kbps(multilink-PPP)
/BoD(Bandwidth on Demand)
Remote Dial-In/LAN-to-LAN
connection
Remote activation
Virtual TA
Firewall Facilities
NAT/PAT, DMZ host, port-redirect /
open port
SPI (Stateful Packet Inspection)
DoS/DDoS protection
Flexible URL content filtering
Rule-based packet filtering
E-mail alert and logging via syslog
VPN pass through
Network Features
DHCP client/relay/server
Dynamic DNS
Call schedule
Radius client
UPnP
Router Management
Quick Start Wizard
Command Line Interface (Telnet)
Telnet remote access support
Built-in diagnostic function
Firmware upgrade via TFTP/FTP
Syslog
SNMP management MIB-II (for
Vigor2510V/Vi)
E-mail Detection
LED flashes to indicate E-mail is
waiting on your mail server (POP3)
3