Back To Factory Default Setting - Draytek Vigor2500V Series Quick Start Manual

Adsl voip router
Hide thumbs Also See for Vigor2500V Series:
Table of Contents

Advertisement

B. For MPoA (RFC1483/2684) Users (refer to the following
figure)
1. Check that if the Enable option is selected.
2. Verify if all parameters of DSL Modem Settings are entered
with correct value which given by your ISP.
3. Verify if IP Address, Subnet Mask and Gateway are set
correctly, or that your ISP requires using DHCP clients to
obtain IP automatically.
Step 5.

Back to Factory Default Setting

Warming: After pressing the "factory default setting", you will loose all
settings you did before. Make sure you have recorded all useful settings.
The password of factory default is null.
A Software Reset
You can also reset router to factory default via Web configurator.
B Hardware Reset
While the router is running (ACT LED blinking), press the button
and hold for more than 5 seconds. The ACT LED begins to blink
rapidly, then release the button. The router will restart with the
25

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Vigor2500V Series and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Vigor 2500vVigor2500viVigor2510vVigor2510vi

Table of Contents