Table of Contents
Advertisement
3ft
4.5ft
1. Ensure that the charging dock is located in an area covered by a Wi-Fi signal.
2. Do not place the charging dock in direct sunlight.
3. Charging dock should be placed on a hard floor, do not place on a carpeted area.
4. Regularly dust off the charging dock to keep charging contacts and front panel clean so they operate properly.
5. Secure excess power cord to prevent the robot from dragging the charging dock.
6. Keep charging area dry.
1.
Place robot on charger and ensure that the metal charging contacts on the bottom of the robot and those on the
charging dock are touching. When the charging contacts are correctly lined up the robot will make an audible beep
and the power light will illuminate.
The white light on the power button will blink while the robot is charging and will turn to a solid white light once the
2.
robot is fully charged.
3.
Before initial use fully charge the robot for at least 4 hours.
When the battery power reaches less than 20% the robot
will shut off the suction power and automatically return to
the charging dock.
The robot may occasionally back up off the charger and
then go forward back onto charger to realign itself if a
better connection is needed with the metal charging contacts.
Please note the robot will arrive with a partially charged
battery. If you start using it before fully charging the battery,
the cleaning cycle will be shorter than normal as it will return to
the dock to recharge when it reaches 20% battery power.
1.
Before use, clear the cleaning area of power cords, pull cords for curtains or blinds, clothing, large debris and fragile
items that robot may get caught in. Do not operate in a room with lit candles or lit fireplace. Clean up any liquids prior
to use. Also be sure to turn on lights in all parts of the house you want the robot to map, if it is too dark the robot may
not enter those zones to map.
2.
The first use of the robot is a mapping mission so that it can create a map that you can edit, use to create specific
cleaning schedules and set up cleaning zones and no-go zones. Please note that while the robot is on its initial
mapping mission it will not be cleaning, it will just be exploring. Also during the initial mapping the robot may bump
into furniture, walls and objects as it learns your house, do not be alarmed. As the robot goes out on more cleaning
runs it will continue to improve its mapping of your house.
3.
It is recommended to regularly monitor the robot during its initial mapping mission to assist if it gets stuck or runs into
issues. If it gets stuck simply pick it up move it away from the obstacle, and remove obstacles if necessary, place it back
on the ground and press start button on robot for it to resume mapping.
4.
Once the robot has completed its mapping mission you can create cleaning zones if you would like to set up cleaning
in special areas such as high traffic spots, add no-go zones and set cleaning schedules that correspond to the specific
areas in your house.
3ft
NOTES
Initial mapping of your home
Charging
NOTES
To effectively extend the battery life, you should:
a.
For the first use, please charge for at least
4 hours.
b.
When the battery is low, please charge as soon
as possible.
c.
If you do not use the appliance for an extended
period of time, fully charge the battery and store
in a well ventilated and dry place.
d.
If the appliance is not used for more than
3 months, charge the appliance for 12 hours.
www.eureka.com
11
Advertisement
Table of Contents
