Water Pump Connection Using The Rheem Iq Link - Pump Controllers - Rheem RPH Series User Manual

Water Pump connection using the Rheem IQ Link – Pump Controllers
J.
1.
Firstly, mount the Dpi Link pump controller in a suitable place, preferably out of direct sunlight
and weather near the pool equipment and circulation pump. Fix the mounting bracket to a solid
structure using the screws and wall plugs kit provided. Then slide the controller on to the
mounting bracket locking it into place. Adjust the screws on the back of Dpi unit to ensure a
snug fit. To remove the unit, lift and gently pull it away from the mounting bracket. (Refer to
the Dpi Link installations instruction manual supplied with the controller for further details)
Then plug in the (supplied) "heater interlock" lead with the green terminal plug into the Dpi
2.
pump controller. Check to make sure this is secure.
3.
Once this is done, cut the female socket off the other end of the lead.
(Note: The female socket is for the RTHP – series heat pump models only)
4.
Then peal the sheath back to expose the inner 2 wires and strip these back, as per the photo
on the right.
22