Quick Set-Up Without Using The Mito Red Light App - mitoredlight MitoADAPT Quick Start Manual

Congratulations on your new MitoADAPT panel! Below is a quick start-up
guide. Please do take the time to read the entire User Manual also included
with your light. An electronic version of the User Manual and other helpful
resources can be found at www.mitoredlight.com/pages/user-manual

Quick set-up without using the Mito Red Light app

Unbox your panel, plug in the power cord, and turn on the
power switch.
This is the Home Screen. Using the '+' and '-' buttons you
can adjust the time for the current session. If all the other
settings look good, press 'GO' to start and stop your session.
From the Home Screen press 'SET' to navigate to the
Settings Screen. To adjust the Default Time, Mode, Bluetooth
connectivity, and Brightness settings press 'SET'.
Press +/- to change any specific setting.
Press 'SET' to toggle between each setting.
Once you have adjusted these settings, press 'GO' to go
back to the Home Screen, and then press 'GO' again to
start/stop your session.
Please note, changing the Default Time on the Settings
Screen will not affect the current session. The panel must
be turned off and back on to display the new Default Time.
www.mitoredlight.com