STEINEL professional Series Manual page 21
Hide thumbs
Also See for professional Series:
- Manual (1048 pages) ,
- Operating instructions manual (137 pages) ,
- Manual (21 pages)
Table of Contents
Advertisement
Available languages
Available languages
Android
Bluetooth visibility
Per default, the product visibility over
Bluetooth is enabled. It is possible
to have the visibility of the products
disabled. The Bluetooth communication
itself is still active but the product is not
accessible.
LED function
Initialisation: LED flashes blue
Normal mode: LED off
Bluetooth connection active:
LED lights up blue
Error: LED lights up red
Make LAN connection with the sensor
• Start web browser.
DHCP is factory-activated.
• Check which IP address the sensor
has been given and use it to open the
web interface.
If no DHCP server is available, the sensor
is configured as followed:
– IP address: 192.168.1.200
– Sub-network mask: 192.168.1.0/24
In this case, the computer must be set to
the same sub-network (192.168.1.0/24).
Instead of using the IP address, the
sensor can also be accessed via the
host name. The standard host name is:
"steinel_" + last 6 characters of the MAC
address.
iOS
Example:
MAC address is CC:BD:35:12:34:56, the
host name is: steinel_123456
You will find the relevant MAC address on
the load module.
A customised network configuration can
be set up via the web interface:
User code: updwd123
Administrator code: adm123
Setting Hallway IP detection
Reach can be set separately for both
directions via Smart Remote app The
Steinel logo on the sensor indicates the
direction. (Fig. 6.1)
a The reach shown by "S" points to the
direction in which the S in the Steinel
logo points.
b The reach shown by "L" points to the
direction in which the L in the Steinel
logo points.
• Setting reach via:
– Smart Remote app
– Web interface
– IP interface
Setting HF 360-2 IP detection
The reach can be set digitally or manually.
• Setting reach via:
– Smart Remote app
– Web interface
– IP interface
• Adjust the reach via shroud foils.
(Fig. 6.2, Fig. 6.3, Fig. 6.4)
Setting True Presence
• Setting reach via:
– Smart Remote app
– Web interface
– IP interface
First time of using True Presence
During initial commissioning, the pres-
ence detector creates a room image.
- 21 -
®
IP detection
®
Advertisement
Table of Contents
