Download Print this page

Huawei Bar 300 Quick Installation Manual page 2

Advertisement

5
Install the Bar 300 on the display.
A display thinner than or equal to 80 mm (3.15 in.)
is used as an example here.
a
Closely
Do not leave a
attach the
gap between the
front panel of the
L-shaped
bracket to
base and that of
the back
the display.
of the
display.
Wall-Mounting
The Bar 300 can also be installed on a wall if the display is wall-mounted.
Required Materials:
Included: plastic expansion bolts, L-shaped bracket, base, 1/4"-20 UNC screw, and M3 x 6 Phillips flat
head machine screws.
Not included: hammer drill, cordless electric screwdriver, hammer and Phillips screwdriver.
Secure the plastic expansion
1
sleeves to the wall.
Hole diameter: 8 mm (0.31 in.)
Hole depth: 55 mm (2.17 in.)
150 mm (5.91 in.)
3
Install the base.
6
Use velcro tape to secure the L-shaped
bracket.Tighten the M3 x 10 screw.
b
2
Screw the L-shaped bracket with the
tapping screws.
Screw the base with M3 x 6 Phillips flat
4
head machine screws.
5
Route the cables out of the hole in the L-shaped
bracket, and connect them to the Bar 300 by
referring to section Connecting Cables.Install the
Bar 300 on the base and tighten the 1/4"-20
UNC screw.
Ceiling-Mounting
Purchase an additional bracket to mount the Bar 300 to the ceiling. The bracket requires:
• A minimum weight load of 10.5 kg (23.15 lb) and a thickness between 2 mm (0.08 in.) to 3 mm
(0.12 in.).
• A location pillar that fits into the location hole of the Bar 300. The distance between the screw
hole on the bracket and location pillar must be 14.5 mm (0.57 in.) to match the Bar 300.
• A screw hole and one 1/4"-20 UNC screw.
When securing the Bar 300, use the 1/4"-20 UNC screw included with the purchased bracket to avoid a
mismatch.
Mount the purchased bracket on the ceiling as needed, and then install the Bar 300 on the bracket.
Mounting on a Tripod
You can also secure the Bar 300 with a tripod. The minimum weight load of the tripod must be
10.5 kg (23.15 lb). Its mounting platform must match the bottom of the Bar 300.
6
Tie the cables together. (The color
of the cable you use may differ.)
Screw hole
Depth: 4.0 mm
(0.16 in.)
Use 1/4"-20 UNC screws
14.5 mm (0.57 in.)
Location hole
Diameter: 4.3 mm
(0.17 in.)
101.5 mm (4 in.)

Advertisement

loading