Table of Contents
Advertisement
Available languages
Available languages
Press the ON/OFF
heating icon
that the heater is operating in Eco mode.
Use the Up
, Comfort
through them. After a few seconds, the mode icon will stop flashing and the heater
will heat in that mode.
To adjust the set temperature of any of the modes you can press the Setting button
, wait for the
adjust the temperature. The temperature range is from 5-50°C.
To set the timer, press the Setting button
use the Up
hours. The digits will flash while setting and then the screen will return to heating
mode. The Timer icon
been set and the heater will continue to operate until the selected time has elapsed.
To set the child lock function press and hold the Up
will appear on the display screen and the control panel will now be locked. To
disable the child lock press and hold the Down
disappear to indicate that the child lock function is now inactive, and all buttons can
be used again.
To switch off the display light whilst the heater is in operation press and hold the
button for 5 seconds. Press the
back on.
Eco Mode – In this mode the heater works at low power. For example, if the heaters full
capacity is 2500W, in eco mode it would operate at 1000W.
Comfort Mode – When the heater is operating in comfort mode it is running at its full
capacity, thus, if it is a 2500W heater it will operate at 2500W.
Anti-frost Mode– This mode is specifically designed to prevent frosting. When the ambient
temperature is below 5℃ the product will begin to operate. If the ambient temperature rises
greater than 7℃ the product will automatically cease heating.
Remote Control – The remote-control use distance is 2M. All control panel functions are
the same as the remote control.
button to initiate heating. When the heater is switched on the
and the Eco mode icon
and Down
buttons to cycle between the heating modes: Eco
and Anti-frost mode
light to flash then use the Up
and Down
buttons to adjust the time. The timer range is 1-24
will not appear on the display to indicate that a timer has
will illuminate by default. This means
. The mode icons will flash as you cycle
, when the Timer icon
button. The padlock icon
button again to switch the display light
17/38
and Down
button. The padlock icon
buttons to
flashes
will
Advertisement
Table of Contents
