Blower Operation - Vacmaster PROFESSIONAL VJF608PF 0202 Operator's Manual

IMPORTANT! When vacuuming large quantities of liquids, do not immerse the nozzle completely
capacity. You will notice an increase in motor speed. When this happens, turn off the machine,
disconnect from power supply, and drain the liquid into a suitable receptacle or drain. To continue
off and remove plug from power supply. Empty the collection tank, clean and dry the inside and
outside before storage.
REMEMBER!
must be installed before dry vacuuming again.
1
6
This Wet/Dry Vacuum has blowing capabilities. To use the blower feature, follow the instructions
listed below.
WARNING:
IN CANADA, CSAZ94.3) BEFORE USING BLOWER.
CAUTION:
WARNING:
INHALED.
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Make sure the collection tank is empty before using as a blower. Clear all dirt and debris from
the hose and collection tank.
3. Remove the hose from the vacuum port.
4. Insert the locking end of the hose into the blower port on the back of the powerhead and lock
into place (Fig. 2).
5. The included attachments lock together to prevent them from detaching during use. Connect the
desired attachment onto the end of the hose or extension wand by aligning the tabs and push
together until they lock into place (Fig. 3).

BLOWER OPERATION

2 3
7
ALWAYS WEAR SAFETY GOGGLES COMPLYING WITH ANSI Z87.1 (OR
KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS.
WEAR A DUST MASK IF BLOWING CREATES DUST THAT MIGHT BE
4
13
5