Blower Operation - Vacmaster VJE1412SW 0202 Operator's Manual

4. Verify that the on/off switch is in the 'O' OFF position before plugging the power cord into the
the power cord from the outlet.
7. After use, empty the collection tank by unscrewing the drain cap. Drain liquids into a suitable
IMPORTANT! When vacuuming large quantities of liquids, do not immerse the nozzle completely
capacity. You will notice an increase in motor speed. When this happens, turn off the machine,
disconnect from power supply, and drain the liquid into a suitable receptacle or drain. To continue
off and remove plug from power supply. Empty the collection tank, clean, and dry the inside and
outside before storage.
REMEMBER!
must be installed before dry vacuuming again.
2
7
This Wet/Dry vacuum has blowing capabilities. To use the blower feature, follow the instructions
listed below.
WARNING:
IN CANADA, CSAZ94.3) BEFORE USING BLOWER.
CAUTION:
WARNING:
INHALED.
2. Make sure the collection tank is empty before using as a blower. Clear all dirt and debris from
the hose and collection tank.
3. Remove the hose from the vacuum port. Remove noise diffuser from blower port.
4. Insert the locking end of the hose into the blower port on the back side of the powerhead and

BLOWER OPERATION

3
ALWAYS WEAR SAFETY GOGGLES COMPLYING WITH ANSI Z87.1 (OR
KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS.
WEAR A DUST MASK IF BLOWING CREATES DUST THAT MIGHT BE
4
5
12
6