Spare Parts; Disposing Product; Warranty - NSK Varios 170 Operation Manual

Built-in module
Hide thumbs Also See for Varios 170:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Problem
Item to Check
The handpiece
is overheating.
The water does
not reach to the
handpiece.
Remove the
handpiece from the
No / Weak water.
handpiece cord. Water
does not comes out or
weak from it.
No / Weak water form
the handpiece.
Water is leaking from
the joint between the
Water leakage.
handpiece and the
cord.
Tip oscillate, but
Handpiece LED turns
Handpiece
on and off.
LED does not
illuminate.
Tip oscillate, but
(Varios 170 LUX)
Handpiece LED does
not turn on.
* Repairs cannot be made by the customer.

10. Spare Parts

Model
Sterilization Case
Tip Wrench
( CR-10 )
Tip Holder

11. Disposing product

Consult with dealer from whom you purchased it about waste disposal.

12. Warranty

Manufacturer warrants its products to the original purchaser against defects in material and workmanship under normal
practices of installation, use and servicing. Such expendable items as O-Rings is not covered by this warranty.
Power has not been properly
adjusted for the Tip.
The Tip is not tightened firmly.
Failure of vibration in the handpiece
or the Module.
The water adjustment dial is
closed.
The water filter is clogged.
There may be exogenous material
in the hole.
O-Ring at the handpiece cord is
worn or damaged.
The handpiece is not connected into
the Handpiece Cord correctly.
Disconnection in the Handpiece
Cord, or failure in Module.
Products
Order code
Z1035001
Z221076
Z221A080
Cause
Adjust the power level on the Power Guide.
Do not exceed.
Tighten the Tip until the Tip Wrench clicks.
Contact dealer.*
Check the water circuitry and supply to the
Unit Chair.
Turn the water adjustment dial and set it to
an appropriate water colume.
Contact dealer.*
Air it with the appliances such as
syringes from the rear of the handpiece.
If it is still unsolved, contact dealer.
Replace with new O-Ring (Refer to 6 6-3
Changing O-Ring).
Firmly insert the handpiece into the
Handpiece Cord inmost.
Contact dealer.*
Model
O-Ring
Tip Cover S
Autoclavable at 135˚C.
9
Solution
Products
Order code
D0310020080
Z217851

Advertisement

Table of Contents
loading

Table of Contents