Mounting Venturi Tubes Between 600 Mm And 2800 Mm - Honeywell ESSER 781443 Installation Instructions Manual

10.4 Mounting
To mount the air duct (with or without the optional mounting kit Part No. 781449) with a pipe length of more than
600 mm the air duct must be drilled at two points as shown in the figure.
Hole ∅
38 mm
Direction of
air flow
Hole ∅ 50
mm
Fig. 13: Venturi tubes between 600 mm and 2800 m
The Venturi tube must be about 30 mm longer as the diameter of the air duct.
Observe distance caused by the optional mounting kit if required!
Refer to section 10.6 "Mounting the Venturi tube"!
FB 798349 / 04.13
Venturi tubes between 600 mm and 2800 mm
30
Mounting information!
Drill a hole (∅ 38mm) in the air duct and deburr the
borehole.
∅ 38 mm
upper hole
∅ 50 mm
bottom hole
Cut the Venturi tube to the required length
(refer Section 10.5 „Adapt the Venturi tube length").
Seal the borehole of the air duct on the lower end of
the Venturi tube with the supplied plastic gasket
(use only Part No. 781447 / 781448).
Insert rubber gasket in the lower borehole of the air
duct (∅ 50 mm).
Close the end of the Venturi tube by means of
the supplied sealing cap (Venturi tubes between
600 mm and 2800 mm only).
The Venturi tube should not protrude by more than
30 mm above the air duct.
Venturi-Air Duct Kit
29