Table of Contents
Advertisement
Safety
•
Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners.
Use a damp cloth for cleaning. Never use strong solvents, such as thinner or benzine, or abrasive
cleaners, since these will damage the cabinet. Stubborn stains may be removed with a cloth lightly
dampened with mild detergent solution.
•
To ensure the highest optical performance and resolution, the projection lenses are specially treated with
an anti-reflective coating, therefore, avoid touching the lens. To remove dust on the lens, use a soft dry
cloth. Do not use a damp cloth, detergent solution, or thinner.
•
Rated operating ambient temperature: ta= 5 °C (41 °F) to 40 °C (104 °F).
•
Rated operating humidity: 10% RH to 85% RH (non-condensing). This projector can be set to any angle
within 360° range.
•
Allowing proper space around the projector is critical for proper air circulation and cooling of the unit. The
dimensions shown here indicate the minimum space required.
100 cm
(39.4")
Image 1–1
1
Bottom intake vents.
2
Ceiling mount plate.
•
For ceiling mounted installations, make sure to leave 30 mm (1.2") between the ceiling mount and the
bottom intake vents of the projector.
To prevent battery explosion
•
Danger of explosion if battery is incorrectly installed.
•
Replace only with the same or equivalent type recommended by the manufacturer.
•
For disposal of used batteries, always consult federal, state, local and provincial hazardous waste disposal
rules and regulations to ensure proper disposal.
On servicing
•
Do not attempt to service this product yourself, as opening or removing covers may expose you to
dangerous voltage potentials and risk of electric shock.
•
Refer all servicing to qualified service personnel.
•
Attempts to alter the factory-set internal controls or to change other control settings not specially discussed
in this manual can lead to permanent damage to the projector and cancellation of the warranty.
•
Replacement parts: When replacement parts are required, be sure the service technician has used original
Barco replacement parts or authorized replacement parts which have the same characteristics as the
Barco original part. Unauthorized substitutions may result in degraded performance and reliability, fire,
electric shock or other hazards. Unauthorized substitutions may void warranty.
•
Safety check: Upon completion of any service or repairs to this projector, ask the service technician to
perform safety checks to determine that the product is in proper operating condition.
Malfunction unit
Remove all power from the projector and refer servicing to qualified service technicians under the following
conditions:
•
When the power cord or plug is damaged or frayed.
•
If liquid has been spilled into the equipment.
•
If the product has been exposed to rain or water.
14
R5914653 /05
G62
100 cm
(39.4")
100 cm
(39.4")
100 cm
(39.4")
1
10.1 mm
30 mm
(0.4")
(1.2")
2
Advertisement
Table of Contents
