Table of Contents
Advertisement
Continuous Flow Icemaker Service Manual
A
E
UGER AND
XTRUDING
1.
Disconnect unit from power supply.
2.
Remove storage container cover and put aside.
3.
Turn off water supply to icemaker.
4.
After ice has melted from head take hold of the auger nut and lift straight up to disengage from
icemaker.
5.
When replacing the auger assembly, make certain that both the auger engages the output shaft
drive and the extruding head ribs engage the evaporator tube.
I
NSTALLATION AND
1.
Place shaft seal locator seat and shaft
seal mount over gearmotor output shaft
and push down until shaft seal seat and
shaft seal mount rest flush on top of
gearmotor.
2.
Place rubber coated ceramic seal
(important: ceramic face up) over output
shaft and push down until seal nest in
recess of shaft seal mount. (lubricate
rubber on ceramic seal with rubber
lubricant).
3.
Place shaft seal with carbon face down
(spring up) over output shaft and push
(gently) downward until seal rests on
carbon face of the output shaft seal.
4.
Place flat washer over output shaft and let
rest on the output shaft seal. Push down
on the washer compressing the spring on
the output shaft seal. While holding the
seals (down) in place slide the E–ring into
the groove on the output shaft
U
N
PPER
UT AND
The upper white bearing located on top of the auger is used to absorb the force between the auger and
extruding head.
NOTE: The bearings are 3/32 thick. When they wear below 1/16 they should be replaced.
Bearings to be inspected for wear during quarterly maintenance.
To Replace Bearing
1.
Disconnect unit from electric power.
2.
Remove top panels.
3.
Remove Dispense Tray Cover.
4.
Use an open end wrench on auger nut connected to bearing and turn counterclockwise to remove
assembly.
5.
Remove worn bearings. Replace with new bearings and then reinstall assembly.
NOTE: If auger turns with nut, remove cover on top of gearmotor stator and hold motor while
loosening nut.
Publication Number: 630460324SER
H
R
EAD
EMOVAL
S
S
R
HAFT
EAL
EPLACEMENT
B
A
EARING
SSEMBLY
FIGURE 9. SHAFT SEAL 700 AND 1000
- 14 -
E–RING
WASHER, PLAIN FLAT
SHAFT SEAL
MOUNT, SHAFT
SEAL
SEAT, SHAFT SEAL
GEARMOTOR
© 2006-2008, IMI Cornelius Inc.
Advertisement
Table of Contents
