Table of Contents
Advertisement
4
Press ENTER.
The station is stored.
5
Repeat steps 1 through 4 to store
other stations.
To t une in a st at ion w it h a w eak
signal
Press + or – (or TUNING +/– on the remote)
repeatedly in step 2 to tune in the station
manually.
To set anot her st at ion t o an
exist ing preset num ber
Start over from step 1. After step 3, turn the
shuttle until it clicks to select the preset
number where you want to store the other
station.
You can preset a new station in the selected
preset number.
Downloaded from:
https://www.usersmanualguide.com/
To erase a preset st at ion
1 Press and hold TUNER MEMORY until a
preset number appears in the display.
ALL DISCS
2 Turn the shuttle until it clicks to select the
preset number you want to erase.
Select "ALL ERASE" when you want to
erase all the preset stations.
3 Press ENTER.
"COMPLETE" appears in the display.
When you erase a preset number, the preset
number decreases by one and all preset
numbers following the erased one are
renumbered.
To change t he AM t uning int erval
(Except f or t he European and M iddle
East ern m odels)
The AM tuning interval is factory-preset to 9 kHz
(10 kHz in some areas). To switch the AM tuning
interval, tune in any AM station first, then turn off
the power. While holding down TUNER/BAND,
turn the power back on. When you switch the
interval, AM preset stations are erased. To switch
back to the original interval, repeat the same
procedure.
Tip
The preset stations are retained for half a day even if
you unplug the power cord or a power failure
occurs.
VOLUME
ß
11
Advertisement
Table of Contents
