Silhouette Cameo Pro User Manual page 30

Silhouette Cameo® 4 Pro User Manual
Replace the Crosscutter Cartridge
If your crosscutter blade becomes dull and you need to replace it, you can do that easily by removing and replacing the
crosscutter cartridge.
To remove the crosscutter cartridge, press down on the top of the two end levers simultaneously. While doing that, pull
the crosscutter cartridge out. It will be the long piece that is shown below.
Note: Make sure the crosscutter is in the locked position before you attempt to remove the cartridge.
Lever Lever
Crosscutter Cartridge
To insert the crosscutter cartridge back in the machine, line up the feet at the bottom of the crosscutter cartridge with
the grooves at the bottom of the crosscutter cartridge opening on the Cameo. Once you're sure the alignment is correct,
lift the top of the crosscutter cartridge and push it into the opening until you hear it click into place.
Lever
Lever
Foot
Foot
28