Silhouette Cameo Pro User Manual page 28

Silhouette Cameo® 4 Pro User Manual
Use the Roll Feeder or Mat Support
Below are the roll feeder pieces come with the Cameo Pro. In addition to those pieces, there is also a piece that you can
use to support your cutting mat when you need it.
Left tray piece
Middle roll feeder piece
Middle support piece
Connecting piece
Right tray piece
To assemble the roll feeder or mat support options, line up two end tray pieces you want to use in addition to either the
middle roll feeder piece OR support piece. Secure these pieces underneath the Cameo Pro machine. Use the long piece
to connect the two end pieces of the tray.
Roll feeder Mat support
For the roll feeder, when your tray is assembled, adjust the middle piece to that it will accommodate your size of rolled
material. The ends of the material should rest on the ends of these two pieces. Slide the middle roll feeder piece to
match the width of your material.
Place your rolled material on the roll feeder. Take the end piece and feed it through the roll feeder slot. Then feed it into
your machine using the Load button on the touch panel. Make sure the material is feeding straight into the machine.
When you're finished using the roll feeder or mat support, remove the roll of material or cutting mat from the machine.
Then disconnect the connecting piece from the assembled pieces and lift the machine to remove the remaining pieces.
26