Related Manuals for Infineon EASY3452
Summary of Contents for Infineon EASY3452
- Page 1 EASY3452 Getting started Infineon Technologies EASY3452 V1.1 – PUCCINI Evaluation System Getting Started 2000-03...
- Page 2 EASY3452 Getting started 1.1 Introduction This document explains briefly how to install and run an EASY3452 V1.1 PUCCINI evaluation system. 1.2 Overview The EASY3452 consists of an evaluation board, a power supply and documentation. Two LEDs are included. A green LED to indicate that the board is powered and a red LED that shows that the line interface receives no signal (LOS, red).
- Page 3 EASY3452 Getting started 1.3 Setting up the System for an external T3 Remote Loop ½ Use the supplied switching Ac adapter to power up the evaluation board; green LED on. ½ Check the correct function by resetting the board. If power is on and the serial interface is not connected the LEDs should flash once after RESET and then the green and red LEDs should stay on.
- Page 4 EASY3452 Getting started 1.4 Test connectors The evaluation board is equipped with several test connectors to scope, connect or to input signals (see figure 1). XCLK RCLK XJATT XDIN RDON RESQ XDIP RDOP DS3/E3Q DS3/STS-1Q 11 TRSQ LCODE 13 XAIS...
- Page 5 EASY3452 Getting started 1.4.3 JP3 Jumper 3 allows access to the JTAG pins of the device. 1.4.4 JP4 / JP5 The GND of the BNC receive and transmit connectors can be connected to the local analog receive and transmit GND.