Stihl MS 362 C-M Technical Information page 8

Page 7
3
4
.
Fit yellow ground wire connector (3) onto the
contact spring terminal (4) and push them both
onto the filter base.
.
Install the carburetor and filter base.
.
Position black short circuit wire connector in the
switch shaft's guides and push it onto the boss
– crimped side must face up.
.
Fit the baffle.
.
Fit the switch shaft on the filter base.
.
Fit the choke rod.
2
.
Join the connector (1) and push it into the
connector housing (2).
1
Technical Information 04.2013
Installation at fanwheel side
.
Position wires with shrink tube so that the lower
end of the shrink tube (5) is aligned with the
lower guides (arrow).
6
7
8
9
.
Push the yellow (6) and red (7) solenoid valve
wires into the guides on the crankcase.
.
Push the black short circuit wire (8) and the
green/yellow ground wire (9) into the
guides (arrow).
. Install the control unit – see b 4.2.2
.
Assemble all other parts.
5
TI_04_2013_30_01_01.fm