Installing The Driver - NEC N8190-7153 User Manual

4.
Mate the cable connector and the connector of this product firmly in the correct direction.
Notice

Tips
5.
Mate the other end of the cable connector and the Fibre Channel device firmly in the correct
direction.
Notice
Check
6.
Plug the power cord of the Fibre Channel device into the electrical outlet. For detailed
information, please refer to the user's guide of the Fibre Channel device.
7.
Plug the power cord of the computer into the electrical outlet.

4-4. Installing the Driver

To use this product, the appropriate Fiber Channel driver for your operating system must be installed. For
detailed information, please install a driver with reference to the "ExpressBuilder" attached to the server.

Push the latch of the Fibre Channel cable to avoid conflict with the computer
flame and then insert the Fibre Channel cable until you hear it click.
If it is difficult to push the latch of the Fibre Channel cable when connect or remove
the Fibre Channel cable, use a flathead screwdriver to push the latch.
 Do not connect this product to a computer or Fibre Channel device that is not
recommended by NEC Corporation. If the product is connected to a computer or
Fibre Channel device that is not recommended by NEC Corporation, the product
may malfunction or fail.
 Please contact the retailer or service center for the information on recommended
computers, Fibre Channel devices, or Fibre Channel cables.
 Please refer to the user's guide of the product for information on how to setting
Fibre Channel device.
- 39 -