Installing The Driver - NEC N8190-131 User Manual

Mate the other end of the cable connector and the Fibre Channel device firmly in the correct
5.
direction.
Important
Check
Plug the power cord of the Fibre Channel device into the electrical outlet. For detailed
6.
information, please refer to the user's manual of the Fibre Channel device.
Plug the power cord of the computer into the electrical outlet.
7.

4-5. Installing the Driver

To use this product, the appropriate Fibre Channel driver for your operating system must be installed. For
detailed information, refer to the "N8190-131 Setup Card" which is included in "N8190-131 Fibre Channel
controller Windows Driver" as "\Manual\ENG\Setup.pdf".
Do not connect this product to a computer or Fibre Channel device that is not
recommended by NEC Corporation. If the product is connected to a computer or
Fibre Channel device that is not recommended by NEC Corporation, the product
may malfunction or fail.
Please contact the retailer or service center for the information on recommended
computers, Fibre Channel devices, or Fibre Channel cables.
Please refer to the user's manual of the product for information on how to setting
Fibre Channel device.
- 37 -