Installing The Cn4093 - Lenovo CN4093 User Manual

10 gb converged scalable switch
Hide thumbs Also See for CN4093:
Table of Contents

Advertisement

Installing the CN4093

18
CN4093 10 Gb Converged Scalable Switch User's Guide
Note: The following illustration shows how to install the switch in a Lenovo Flex
System chassis. The appearance of your Lenovo Flex System chassis might
be different; see the documentation for your Lenovo Flex System chassis for
additional information.
Use the following instructions to install the switch in the Lenovo Flex System
chassis. You can install the switch while the Lenovo Flex System chassis is powered
on. For redundancy support, you must install I/O modules of the same type in I/O
bays 1 and 2, and I/O modules of the same type in bays 3 and 4 of the chassis.
To install the switch, complete the following steps.
1. Read the safety information that begins on
on page
16.
2. Select I/O bay in which to install the switch.
Note: For details about I/O bay requirements and bay locations, see the
documentation for the Lenovo Flex System chassis.
3. Remove the filler module from the selected bay. Store the filler module for
future use.
4. If you have not already done so, touch the static-protective package that
contains the switch to an unpainted metal surface of the Lenovo Flex System
chassis or an unpainted metal surface on any other grounded rack-component
for at least 2 seconds.
5. Remove the switch from its static-protective package.
6. Make sure that the release levers on the switch are in the open position
(perpendicular to the switch).
7. Slide the switch into the applicable I/O bay until it stops.
8. Push the release levers on the front of the switch to the closed position. After
you insert and lock the switch, it is turned on (there may be a slight delay), and
a power-on self-test (POST) occurs to verify that the switch is operating
correctly.
Note: The switch may take up to two minutes to complete the POST. During
POST, the Power LED continuously flashes. Once POST has successfully
completed, the Power LED remains on and the Error LED is off.
page 5
and
"Installation Guidelines"

Advertisement

Table of Contents
loading

Table of Contents